- #Xd ir cut mini camera user manual install
- #Xd ir cut mini camera user manual code
Spotlight and other light sources will cause screen aging. Do not be a long time the camera toward a strong light source, such as the sun.In a room filled with smoke or dust used. Glasses fogging in the environment can be l used. In the following cases, the lens because of water vapor condensation born fog.įrom the air conditioner off when you open when the high and low temperatures caused by the rapid change.Ĭaused by the door when the switch level of the rapid temperature changes.
#Xd ir cut mini camera user manual install
Do not install the camera near the air conditioner outlet. Camera use temperature of -25 ℃ to 50 ℃, humidity of less than 90%. Do not exceed the limits of temperature, humidity, the use of state of the camera. Note that strictly sealed to prevent liquid splashing into or foreign bodies falling into the ball machine, otherwise it will result in permanent damage to the device. Do not use strong or with abrasive cleaning agents, so as not to scratch jacket, affecting image quality. In use must comply with all electrical safety standards, the ball machine or signal transmission line should work with high-voltage equipment or cables to maintain a sufficient distance (at least 50 meters), if necessary, do a good job against lightning, surge and other protective measures.Ĭleaning the camera housings, please use the dry soft cloth, such as severe dirt, use neutral cleaning agent gently wipe. Power lines, video lines and control lines preferable to use shielded cable and is independent of routing, can not blend together with other lines. The power, video lines and control lines. For security reasons, do not cover the ball is not installed electricity. To be especially careful, light-light, do not force squeezing movement and the structural components, so as to avoid the ball machine trouble. Transport, storage and installation process, we need to prevent stress, severe vibration and damage to the product immersion. #Xd ir cut mini camera user manual code
If you require technical support, please go to the Support page and post a tickets.Factory Configuration: PELCO-D protocol,Baud rate 2400, address code 1 (HIGH -> Normal Mode, LOW -> Night-vision Mode) Thus, you can connect the GPIO from your Pi to this position, and toggle modes by changing the GPIO logic level. To revert to the Normal Mode, please remove the line disable_camera_led=1 then save and restart your Pi.Ģ. There are two ways to toggle between Normal Mode and Night-vision Mode.Įxit with save and restart your Pi then the camera will work on Night-vision Mode. RPi IR-CUT Camera works on Normal Mode by default. Note: With Pi4, you can only switch the IR-CUT by controlling the GPIO instead of setting config.txt file. Raspberry Pi Camera Module, Embedded IR-CUT, Supports Night Vision
0 kommentar(er)
